PROTECT YOUR RIG AND LOAD FROM OVERHEAD DAMAGE!

It's easy to install and use, and best of all, it helps you to avoid expensive damage. Designed and manufactured by an experienced Tractor trailer Driver with Two U.S. Patents.

Pull forward so that the exterior sensor is directly underneath the overhead hazard. The exterior sensor uses sound waves to accurately measure the height of the overhead obstacle.
The in cab programmable readout displays the accurate measurement of the overhead obstacle – you can then decide if it’s safe to pass underneath. 
The GiraffeG4 will continue to measure the height of the overhead obstacle as you pass underneath. 

Recommend to all drivers

I’m originally from Georgia, I haven’t made it to Hawaii cause I can’t get there-the other 49 I’ve pretty much covered all of them. I’ve done everything from dump trucking to semi’s over the road, I’ve done a little bit of all of it, I’m 29 years in. If you’re going to NY, Philly or Chicago the GiraffeG4 is a great tool to have. All the bridges are mismarked. I used to haul prefab houses down in Georgia-18ft high. I wish I had the GiraffeG4 back in those days- I wouldn’t feel safe traveling without it anymore. I would recommend it to any driver, all drivers, they should have it.

– Robbie W., GA 

Using the GiraffeG4 gives me the extra bit of confidence

Using the GiraffeG4 gives me the extra bit of confidence – along with my high pole to protect the load, if I have contact on the pole and need to back up to remeasure the GiraffeG4 gives me a readout of the height so I can inform the driver of the height. The GiraffeG4 is a great tool for the high pole car operator and for the driver with no pole car. This will give him the measurements as he is slowly going under a bridge that may be mismarked and he will be able to stop and back out and save the load from being damaged. PS: I have fourteen years experience and I think GiraffeG4 will give you the edge to do a great job and to protect the load.

– WD Pilot Car, Bristol, IN